[Elecraft] modification K2 use for KPA100

[Christophe aufacf]

hello don  and All ,

Thank you for the info

I'm going back to my K2

73 , F8ACF

#K2 7369 + KP100 in progress

Le lun. 6 avr. 2020 à 23:33, Don Wilhelm <donwilh at embarqmail.com> a écrit :
>
> Christophe,
>
> Since your K2 is SN 7369, it does not need any modifications or
> alignment to add the KPA100 - that 10/12m VFO/ALC Mod kit is only for
> older K2s, those component changes are already present in your K2.
>
> You will have to add the headers on the RF Board if they are not already
> present.  The KPA100 manual will tell you when to install them.
>
> 73,
> Don W3FPR
>
> On 4/6/2020 4:03 PM, Christophe aufacf wrote:
> > Good afternoon all
> >
> > for the modifications of the K2 to put a KPA100
> >
> > must be done before putting the KPA100 so measurement and adjustments
> >
> > or can this be done once KP100 is set and installed?
> >
> > could give me the page in the manual of K2 or aligns 12 / 10M ?
> >
> > thank you in advance, I'm happy to get back on my K2 after more than 3
> > years off, so I have to get back in the bath
> >
> > # K2 7369 + KPA100 in progress
> >
> >



-- 
73 , F8ACF56