[Elecraft] K3 - NOT K3S - issue: TX Calibration fails on 6m only

[hawley, charles j jr]

Other than using a computer, is there a menu item where the tx calibration values can be seen?

Tha manuals are pretty much assuming that you have a computer and still have the one that you did the calibration on. 

Chuck Jack Hawley 
KE9UW

Sent from my iPhone, cjack 

> On Apr 5, 2020, at 7:24 PM, Don Wilhelm <donwilh at embarqmail.com> wrote:
> 
> Jim,
> 
> If I am not mistaken, if the K3 Utility TX Gain calibration fails on any band, no calibration information is stored in the K3.  If you do it manually, it will save on a band by band basis.
> 
> 73,
> Don W3FPR
> 
>> On 4/2/2020 9:12 AM, Jim Spears wrote:
>> I am helping a friend upgrade an older K3/100 (s/n 798) after he recently
>> acquired it from estate of a SK.  I have brought firmware forward one or two
>> versions and installed the KIO3B board set.  The radio has main RX only and
>> the KSYN3A upgrade.  It does have the KANT3 antenna tuner.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to c-hawley at illinois.edu