[Elecraft] alignement KPA100

[Christophe aufacf]

hello Don, hello everyone,

I would like to be sure about 2 measurements on page 44 for my KPA100
Q9 tab: tad; is this the radiator? infinite measure
for the central pin of J2, I also find: infinite

the question is are the measurements good?

the whole thing being to have a good base

thank you Don and all of you for your help

# K2 7369 + KPA100 in progress


Le dim. 5 avr. 2020 à 22:09, Don Wilhelm <donwilh at embarqmail.com> a écrit :
>
> Your post made it to the reflector OK.
> You must use plain text, HTML will be rejected.
> Direct email to elecraft at mailman.qth.net.
>
> What is your problem with the K2 and KPA100?  The instructions for
> alignment of the KPA100 are in the manual.
>
> 73,
> Don W3FPR
>
> On 4/5/2020 3:12 PM, Christophe aufacf wrote:
> >   hello  to all ,
> >
> > I am subscribed to the elecraft list, I receive the list well but I am
> > unable to send messages
> >
> >    would it be possible for you to see what's going on?
> >
> > thank you in advance I would like to continue my K2 after 3 years of
> > stopping
> >
> > as i need to ask questions thanks again
> >
> >



-- 
73 , F8ACF56