[Elecraft] K1 20m power out

[Don Wilhelm]

Lloyd,

The first thing you should do is adjust the Pre-mixer and RF Bandpass 
filters for the 20 meter band.  See the K1 manual for the adjustment 
procedure.

If that does not bring the output up to at least 5 watts (when using a 
13.8 volt or greater power source), then suspect the 22MHz crystal used 
for the 20 meter mixer.

73,
Don W3FPR

On 9/9/2019 9:14 PM, LL wrote:
> I recently bought a two-band K1, s/n unknown. It puts out 6W on 40m, but
> only one watt on 20m, measured with a WM-2 and a dummy load... and the
> display on the rig. Internal ATU installed. 13+V supply.
> 
> What to check first? etc.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to donwilh at embarqmail.com
>