[Elecraft] KPA 500 Attenuated Receive Signals

Dr. William J. Schmidt bill at wjschmidt.com
Sun Sep 8 11:07:45 EDT 2019


I had the exact same problem with my KPA500.  I inadvertently left it
connected in a lightning storm in the Caribbean and, after some diagnosis on
my RF bench, I found that the PIN diodes on the receive side were blown.
Replacing them cured the problem.  While in there be advised that there is
an upgrade kit for some components in that circuit.  Contact Elecraft techs
for more info.


Dr. William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ 

email:  bill at wjschmidt.com



-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Barry Simpson
Sent: Sunday, September 8, 2019 1:34 AM
To: Elecraft Mailing List <elecraft at mailman.qth.net>
Subject: [Elecraft] KPA 500 Attenuated Receive Signals

My KPA 500, which is several years old, has just developed an issue which so
far I have been unable to resolve.

What has happened is that when I put the amplifier into OPER, the received
signal strength drops by several S units. It transmits normally and also
receives normally in STBY.

The issue occurred when I was changing rigs to use with the KPA500.
Specifically I connected a Ten Tec Omni 6 but I cannot see how that could
have caused the issue. However, the KPA500 now exhibits the same issue with
my TS990 which it never has before.

I believe that some considerable time ago, I did experience a similar
situation and after reading all the manuals etc I found a way to resolve it.
However, I have read the manual until I am blue in the face but I cannot
find an answer this time.

Of course I may have initiated a fault in the KPA500 but I would be
surprised as it has taken all the mistakes I have thrown at it over the
years and it has not so much as blinked.

Any suggestions on how to sort the issue out, or what damage I might have
caused to the switching circuitry, would be appreciated.

Thanks in advance.

Barry Simpson  VK2BJ
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to bill at wjschmidt.com 


---
This email has been checked for viruses by AVG.
https://www.avg.com



More information about the Elecraft mailing list