[Elecraft] KXBC3 question

[Grant Youngman]

 The LO SUPPLY message indicates the power supply is delivering less than 13.8vdc at the KX3.   Can you adjust your supply voltage a bit higher?


Grant NQ5T
KX3 (8342)/KXPA100


> On Oct 14, 2019, at 12:10 AM, Eddy Avila <k6sdw.usa at gmail.com> wrote:
> 
> My KX3 is about 2 years old, recently I set he The KXBC3 to 16hr charge
> and powered down the KX3 and everything looked normal. However, a few hours
> later I noticed the Lo-Supply message was flashing on and off, but when I
> checked the KX3 was getting 13.61vdc and I believe charging was still
> taking place.
> 
> So, charging voltage had not changed, but the Lo-Supply message kept
> flashing until I cancelled battery charge. Any suggestions why the KX3 was
> displaying Lo-Supply with the KX3 powered off but 13.61vdc was measured at
> the rig?
>