[Elecraft] NCC-2 noise canceller with K3s?

[Peter Dougherty]

What I have now is the K9AY as the main antenna on the 1026, and the
random-length vertical with two radials as the second "Aux" antenna. The
adjustment is extremely finicky. The phase control has a hair trigger
basically. Plus I can't really equalize the signals since the vertical aux
antenna can't hear as well as the K9AY.

I'm trying to figure out how I could use the combination of my TX antennas
(which run through the antenna switch) versus the K9AY, and use the AUX
antenna strictly for diversity RX on the K3s, which works somewhat
brilliantly on 40m, but doesn't do much on 80/160.

 - pjd

-----Original Message-----
From: elecraft-bounces at mailman.qth.net <elecraft-bounces at mailman.qth.net> On
Behalf Of Dick Dickinson
Sent: Tuesday, November 26, 2019 9:38 PM
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] NCC-2 noise canceller with K3s? 

Have you tried the current antenna setup with the 1026..?  Did it perform at
all?  If not, what were the perceived shortcomings?

My guess is that with what you have and no changes other than the noise
canceling unit, you'll get about what you are now getting, only more so with
the NCC-2.