[Elecraft] K3 Monitor on Line Output

[K9MA]

Thanks, Ken. I didn't think to check the firmware release notes. That 
feature was added in 2017.

73,
Scott K9MA


On 11/17/2019 16:39, Ken K6MR wrote:
>
> I think you are looking for the Tx line out monitor level.  LIN OUT 
> (from Config menu) and press 2.  0 should give you no monitor output.
>
> Ken K6MR
>
> *From: *K9MA <mailto:k9ma at sdellington.us>
> *Sent: *Sunday, November 17, 2019 14:29
> *To: *elecraft at mailman.qth.net <mailto:elecraft at mailman.qth.net>
> *Subject: *[Elecraft] K3 Monitor on Line Output
>
> On SSB, I have the monitor level set to zero, and hear nothing in the
> headphones. However, when I record the audio from the line outputs, I
> get my own audio when transmitting, at a much higher level than the rx
> audio. (LIN OUT nor 050) (No, it's not the mic on another headset
> connected to the computer.) I can't find anything in the manual about
> this. At the very least, it would be helpful to be able to match the
> levels of the TX and RX audio. Am I missing something? Any suggestions?
>
> 73,
>
> Scott K9MA
>
> -- 
> Scott  K9MA
>
> k9ma at sdellington.us
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to k6mr at outlook.com
>

-- 
Scott  K9MA

k9ma at sdellington.us