[Elecraft] Batch programming with KX3 Utility program?

[Don Wilhelm]

Kevin,

I don't think you can do that with a KX3 Utility configuration file.
But you should be able to do it with Macros - look at the commands in 
the K3/KX3 Programmer's reference.

An advantage of using Macros, is that they are stored in the KX3 and not 
in a computer file, so no worry about the OS running on the computer.

A side comment -- Why are many inserting hyphens in Elecraft model 
designations?  It is KX3 (not KX-3), K3 (not K-3), K3S (not K-3S), etc.
There are only 2 exceptions to this - the Elecraft N-Gen and K-Pod.
Look at the Elecraft products - no hyphens.  Leave the hyphens to other 
manufacturers who change the number after the hyphen to designate an 
"upgraded" version that you can only obtain by buying the new model.
The Elecraft KX3 is not an upgraded KX2, it is an entirely separate radio.

END RANT

73,
Don W3FPR

On 11/12/2019 4:25 PM, Kevin Zembower via Elecraft wrote:
> Hello,
> 
> My club is running a KX-3 with a Windows (7? something old and at end of 
> life) workstation. I've installed the KX-3 Utility program and have used 
> it successfully to program the radio and save the configuration.
> 
> I recently wrote about using different headsets in place of the MH-3 
> mic. I'm going to test the suggestions and advice this Thursday when I 
> go to the club. However, if I'm successful, it looks like there might be 
> a half-dozen or more configuration changes to be made to switch between 
> different headsets or back to the MH-3 mic.
>