[Elecraft] KAT-500 remote control using serial port

[Jack Brindle]

David;

Sorry I didn’t’t have the opportunity until now to answer your question…

The answer is in the KAT500 Programming reference. You probably want to use 38400 bps, 8 N 1 to communicate with the KAT500, as is described in the Serial Port Overview section of that manual.
The manual is available at the same place as the operations manual.

73!
Jack, W6FB


> On Nov 8, 2019, at 9:12 PM, DAVID INGEBRIGHT <daveingeb at comcast.net> wrote:
> 
> I have the KAT-500 Utility working fine through the serial cable and USB. Now to get it running over the internet on the RRC 1258. Using the RRC COM 2 Port, the set up wants to know the serial protocol, The stop bits, the data bits and the parity. I see someone asked that back in 2014 but can't seem to find the answer. Cannot find this info in the KAT500 manual.
> de Dave WB7ELY
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to jackbrindle at me.com