[Elecraft] K2/100 Power Measurements

[Holger Doerschel]

Hi,

after I finally installed the KAF2 module in my K2/100 05775, it was 
time to do a complete alignment and I ran into this old problem again.

The output power at 160 m is 100 W. And drops from band to band to 80 W.

Now I have adjusted the KPA100 to 10m. Now I have there 100 W but then 
on 160 m 120 W.

Measured with an LP-100A and dummy load. SWR is fine!

It looks as if the whole power measurement shows a certain skewness.

Any hint?

73s, Holger DL9HDA