[Elecraft] Problem with K3 driving old tube amp

[Kurt Cramer]

Do you have the ALC hooker up?

Kurt

> On May 31, 2019, at 4:21 PM, William Stewart <wks9478 at charter.net> wrote:
> 
> All,
> 
> I am trying to bring a Drake L-4B to life. I have done the power supply rebuild, the soft-start and other mods. I have also directly grounded the grids of the 3-500Zs (Eimac brand). In driving it with my K3 (SN 51XX, software up to date) I find that the RF power stair-steps to the set power in a hesitating way over a few seconds. This happens sending Morse code or using the "Tune" button.
> 
> The supply voltage, as monitored on the K3 display, is at about 13.4 volts when transmitting.
> 
> I have a power/SWR meter between the K3 and the amp and it shows a low SWR at all times, as does the K3 SWR meter.
> 
> The power meter between the K3 and the amp shows the power gradually increasing. As the K3 increases power out, the amp power out increases in a similar fashion.
> 
> I see no indication of oscillation. The power meters on the output side of the amp show no power when the amp is keyed but no RF is supplied. I placed a low-pass filter (41 MHz cutoff) between the K3 and the amp to no effect.
> 
> I notice that if I send a series of Morse code characters such that the K3 transmit delay timer never times out, once the power ramps up to the set value, it remains solid until the timer expires - when I start transmitting again, the power step process repeats.
> 
> When I put the amp in Standby, the K3 functions normally.
> 
> This smells like an oscillation problem, but I see no evidence of one.
> 
> Any advice would be appreciated.
> 
> Thanks,
> 
> Bill K5EMI
> 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html