[Elecraft] K3, KPA500, KAT500 and 2M brick amp keying

[Jim Rhodes]

I don't have room to set it all up right now, but I have done that in the
past. Just left the KPA500 & KAT500 unpowered. Also with an external 430
transverter and amp.

Jim Rhodes
K0XU

On Wed, May 29, 2019, 08:10 Mike Sanders <k0az at centurytel.net> wrote:

> I have a K3 with built in 2M transverter. The K3 drives the KPA500 and
> KAT500 with the KPAK3AUX. Everything works
>
> fine. I do not have the key line interrupter installed. Reading notes 5
> and 6 on the KPAK3AUX I am a bit confused.
>
> I want to key a 2M brick amplifier with the key out line on the K3. Can
> this be done without the key line interrupter in place?
>
> Or is the interrupter necessary to do this.
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>