[Elecraft] Settings for CW decoder in K3

[Don Wilhelm]

A moderate bandwidth like 400 Hz will also help provide good decoding.

73,
Don W3FPR

On 5/26/2019 9:51 AM, Nr4c wrote:
> First, press SPOT to “ zero-beat” the signal. Then adjust the threshold so that the CWT bar is flashing with the signal. This should work.
> 
> Sent from my iPhone
> ...nr4c. bill
> 
> 
>> On May 25, 2019, at 11:03 PM, Ignacy <no9e at arrl.net> wrote:
>>
>> I am trying to use the CW decoder in K3 to help copy fast exchanges. It is
>> hit and miss. The CW decoder in KX3 is better and so is the external CW
>> Decoder by WD6CNF (spkr to MIC).
>> Ignacy, NO9E
>>
>>
>>
>> --
>> Sent from: http://elecraft.365791.n2.nabble.com/
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>