[Elecraft] Connecting SDRPlay to P3 IF OUT, to CW Skimmer

[Peter Dougherty]

I bought an SDR Play 1A at Dayton with the intention of feeding its RF IN
port from my P3's IF out. I don't have a separate multi-band antenna that I
can dedicate to the SDRPlay, so I think I need to go the IF Route. I run
full legal-limit TX power from antennas in the center of a small city lot,
so even if I put up a separate RX-only antenna, I would probably risk
damaging the SDR, and also it would not be able to hear the weak signals
that my tower-mounted Yagis are picking up and supplying to my K3s.


I then need to feed the SDR output into CW Skimmer so I can populate my own
bandmaps in N1MM and DX Lab Suite. 

Has anybody successfully done this, and if so, is there a step-by-step
tutorial somewhere that I can reference? Or conversely, if someone wouldn't
mind taking a few minutes to walk me through this I'd be extremely grateful.
I'm getting precisely nowhere at the moment.


---------------------------------------------
73 and Good DX
Peter, W2IRT



President, North Jersey DX Association

DXCC Card Checker
Letter O Manager, ARRL Incoming 2nd District QSL bureau