[Elecraft] K1 manual revisions

[Petr, OK1RP/M0SIS]

Hi Don,

perfect. many thanks for few hints.

i will do it step by step.
At first I will check physicaly the parts and soldering around the Q5.
Then after I will try to measure the POWER voltage line (R10) for its
stability.
If needed i can replace both the Q5 and D18.

the only I am worrying a bit about the factory reset if MCU/DAC sampling
issue
as I am not sure what should be re-aligned then after. I read in manual "VFO
calibration etc."
So I hope that it will not be needed...

I will let you know soon.
In any case many thanks Don for your assistance and help.

73 Petr



-----
73 - Petr, OK1RP 
"Apple & Elecraft freak"
B:http://ok1rp.blogspot.com
MeWe: https://bit.ly/2HGPoDx
MeWe: https://bit.ly/2FmwvDt
--
Sent from: http://elecraft.365791.n2.nabble.com/