[Elecraft] Lack of receive signal

[Mark Musick]

Good one Don.
I forgot about that one. HI

73,
Mark, WB9CIF

-----Original Message-----
From: elecraft-bounces at mailman.qth.net <elecraft-bounces at mailman.qth.net> On Behalf Of Don Wilhelm
Sent: Sunday, May 12, 2019 17:22
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] Lack of receive signal

Also check to make sure you have not inadvertently selected the RX ANT - that is also a per band setting.

73,
Don W3FPR

On 5/12/2019 11:55 AM, Mark Musick wrote:
> Jack,
> Check the ANT selection. On 40 meters is the ANT selection on ANT2 when it should be set to ANT1?
> 
> 73,
> Mark, WB9CIF
> 
> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net 
> <elecraft-bounces at mailman.qth.net> On Behalf Of Jack Colson
> Sent: Sunday, May 12, 2019 15:38
> To: Elecraft at mailman.qth.net
> Subject: [Elecraft] Lack of receive signal
> 
> I just noticed that my K3 (s/n 1169) is not hearing signals on 7MHz. actually are attenuated to the point where they are almost non-existant.  I checked the att and pre amp setting and both seem to have an effect on the background noise but still no received signal !  I do not have a know weak signal source (shame on me).  I will start checking other bands as well but 40 is shot.
> 73 and thank you,
> Jack, W3TMZ
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html