[Elecraft] KX3 Issues

[Bill Frantz]

I should note that the ribbon cable was not loose. It was fully 
inserted when I pulled it out and pushed it back in and things 
started working.

73 Bill AE6JV

On 5/6/19 at 7:46 AM, elecraft at mailman.qth.net (David Thompson 
via Elecraft) wrote:

>Good morning reflector peeps…
>
>As a new operator and a relatively new owner of a new-to-me 
>KX3, this was a good thing to read. No, I do not have problems 
>with any of the buttons of my KX3. But, that little radio goes 
>a lot of places with me and this will be something I remember 
>should the need arise.
>
>Thanks and 73 de AG7TX...
>
>David Thompson, AG7TX
>Jack of All Trades
>Master of None
>dbthompson at me.com
>
>
>
>
>>On May 6, 2019, at 05:33, Bill Frantz <frantz at pwpconsult.com> wrote:
>>
>>Thanks. I unplugged and replugged the ribbon cable and the buttons started
>working again.
>>
>>73 Bill AE6JV
>>
>>On 5/5/19 at 7:37 PM, wunder at wunderwood.org (Walter Underwood) wrote:
>>
>>> I would open it up and reseat the ribbon cable connectors. If that
>doesn’t work, I’d save a config, EEINIT, and reload the config.
>>>   I’ve had weird button behavior issues fixed by each of those.

-------------------------------------------------------------------------
Bill Frantz        | Re: Hardware Management Modes: | Periwinkle
(408)356-8506      | If there's a mode, there's a   | 16345 
Englewood Ave
www.pwpconsult.com | failure mode. - Jerry Leichter | Los Gatos, 
CA 95032