[Elecraft] KPA1500 PA Current

[Gary J Ferdinand]

I’m in the process of checking out my amp.  I have two dipoles (40 and 80).  At resonance both show a 1.2:1 SWR with ATU totally bypassed.  With ATU on, it remains bypassed on 80, but shows only the ATU ON LED on 40.  In both cases the resultant SWR is 1.2:1.   SWR measurements are from the KPA1500 display.

When I use the amp with my K3 and drive it up to 1500W, I am occasionally getting an excessive PA current fault at 63A.  From a cold start it’s 60A, but as it warms up in contest usage I find the power drops off, so I have to adjust the K3 to bring it back up to 1500W.  At that point the PA current goes over 60A.

Interestingly, into a dummy load the 1500W point shows a PA current of only 55A.  So the 1.2:1 SWR, be it via a bypassed ATU or using the ATU, is sufficient to raise the PA current eventually to excessive levels.

Suggestions?   I don’t want this to be flipping out during a contest.  I also don’t want to reduce power into what should be a totally acceptable load.

73

Gary W2CS