[Elecraft] Elecraft K-2 Question

[William Aycock]

A question if you please.

I am assembling a K-2. At present, I am currently in the Alignment and 
Test section, Part II. Page 65 covers the BFO test where you use Band+ 
and Band- to check for BFO range.  When I press Band+, the frequency 
counter initially reads around 1.480 MHz and starts increasing in 
frequency. I am guessing about 100 kHz per minute.  When I press Band-, 
I get a good reading of 4.911 MHz.  All of the other checks thusfar in 
this Part II have been good. This is puzzling and I hope someone can 
give me some ideas.

Thanks,

Bill KC5MN