[Elecraft] K3 w/RSP2 & SDR uno

[Bob Conder]

Rich - thanks. The KXV3 is installed. Just need some BNC connectors.Tnx, Bob K4RLC

      From: Richard Ferch <ve3iay at gmail.com>
 To: elecraft at mailman.qth.net 
 Sent: Saturday, March 2, 2019 10:08 AM
 Subject: Re: [Elecraft] K3 w/RSP2 & SDR uno
  
If your K3 has the KXV3 option installed (a row of 5 BNC connectors just
above the CW and PTT keying jacks on the lower right back panel), then
there are two ways.

1) Connect the SDR to the IF Out jack and tune the SDR to the K3's IF (8215
kHz). You can receive signals in (or near) the same band as the K3.

2) Connect a jumper from the RX Ant Out jack to a splitter, one output of
the splitter to the RX Ant In jack and the other to the SDR, select the RX
Ant from the K3's front panel, and tune the SDR to a frequency on the same
band or a lower-frequency band (signals on higher-frequency bands are
attenuated by the K3's low-pass filters).

73,
Rich VE3KI
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html