[Elecraft] K3S glitching on startup

[Nr4c]

Call support. 

Sent from my iPhone
...nr4c. bill


> On Jun 25, 2019, at 12:07 AM, Frank O'Donnell <vfo77 at inkbox.net> wrote:
> 
> This evening I used my new K3S for a normal session of FT8 (K3S connected to computer via a single USB cable for both CAT control and audio transfer), then powered it down.
> 
> When I powered it up later, the following occurred:
> 
> -- It did not display the normal startup message
> 
> -- It rapidly switched from DATA to CW mode, remaining there
> 
> -- Started beeping a number of times per second, continuing indefinitely
> 
> -- Showed "VOX -- OFF" on the display.
> 
> Wondering if this could have been caused by unintended pressure on the CW paddle, I unplugged it but this made no difference. The K3S continues to go into this state each time I power it down and restart it. I'm unable to change mode, band, etc.
> 
> Any suggestions for resolving this? Thanks in advance.
> 
> 73,
> 
> Frank K6FOD
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to nr4c at widomaker.com