[Elecraft] K2 - Is there a way to permanently set the AI1 Parameter?

[Harry Yingst]

I have an external amplifier that can follow the band changes on the K2 by reading the frequency data from the serial output.
To enable this the command AI1; needs to be sent to the K2 first.

The issue is that if the K2 is powered off the command AI1; needs to be resent again at power up since it will not survive a power cycle.
 Is there a way to permanently set the AI1 Parameter?


If not it appears a solution may be to program a small micro controller to send that command upon power up (with a small delay).

Thank you.