[Elecraft] K3: Antenna not connecting on change to BC frequencies

[Nr4c]

Maybe the question is does the K3 store antenna selection for bands other than ham bands?

Sent from my iPhone
...nr4c. bill


> On Jun 4, 2019, at 9:09 PM, Nigel <zl2df at xtra.co.nz> wrote:
> 
> I recently purchased K3-100 s/n 20xx fitted with 2.7/400/250 filters, KAT3,
> KIO3 & KBPF3.     Loaded into memory-3 is 3535 cw and in memory-1 0.917.5
> AM. 
> 
> If, after selecting memory 3 I select memory 1, the frequency changes but
> the antenna does not reconnect. (a weak signal is heard).     If I tap ANT,
> A/B or REV the antenna connects and levels jump to 40 over S9. 
> 
> Tuning down from 1.800 there is a relay change click heard at 1.700, at this
> relay change the antenna also disconnects.       Rocking the vfo up and down
> about 1.700 connects and disconnects the antenna.
> 
> 
> 
> Is this a menu setting I am missing or something else?      Suggestions?
> 
> 73
> 
> Nigel ZL2DF
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to nr4c at widomaker.com