[Elecraft] KAT Problems

[Bob McGraw K4TAX]

From your earlier with the tuner and amp not switching, I would connect the cable ACC direct to the amp from the radio.  If the amp switched then issue is with the tuner. If the amp doesn't switch this points to the radio. 

Recheck all of your CONFIG settings in the radio. 

Looks like a call to Elecraft is in order. 

Bob, K4TAX


Sent from my iPhone

> On Jun 2, 2019, at 9:31 AM, Paul Ecker <eckerpw at gmail.com> wrote:
> 
> Bob - checked all the cables - all tigh and well seated. Still same problems
> 73 Paul w2eck
> 
> 
> 
> 
> 
> 
> 
> 
> *Paul:I would check the cables to be sure they are correctly seated
> and secured for the ACC buss from the radio to the ATU and KPA500. It
> maybe that the radio is not sending the commands to the ATU and then to
> the KPA500.I followed the drawing in the KAT500 manual, Figure 1 on page
> 5.73Bob, K4TAX*
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>