[Elecraft] K2 connecting to N1MM on Laptop

[Ray S]

Hi Don
Yes, I guess I was expecting to be able to assign the COM port in the K2. However I followed your suggestion & the laptop assigned COM3 to the USB/RS232 adaptor & confirmed that the driver is OK & the device is working.
But when I connect the K2 to the 4 wire cable, open N1MM+ & enter COM3 in the N1MM Config/Hardware tab it doesn’t recognize the K2 frequency etc. Maybe I’d better check the cable before anything else.
73 Ray G3XLG

Sent from Mail for Windows 10