[Elecraft] K3S HDSDR as a panadapter with IF out

[Conrad PA5Y]

Hi Gernot this does not work, the Perseus has an ExtIO.dll for HDSDR so for an input I selected Perseus HF Receiver.  However you set me along the right path.

Input mode for RX is I left Q right.
RF Front end calibration SDR on IFD output controlled by Omni-Rig (2 in my case)
Full sync in both directions.
IF frequency 8215000 Hz
Global offset in my case is -2435 Hz but I have not yet calibrated the K3S as I will be locking to 10 MHz as soon as the hardware arrives.

I have also found it best to only Sync to omnirig  and not from omnirig to allow VFO fine tuning without Omnirig and the K3 VFO fighting with each other.

That's it and it seems to work well but I may change a few things, I have the Perseus set to 500 kS/S so I can see 450kHz of band, I am not sure what the BW of the IF output is but it looks flat.

73

Conrad PA5Y