[Elecraft] Does the KX2 have Squelch?

[Paul Gacek]

Thanks Mike and I have Squelch working.

Paul

> On Jul 6, 2019, at 8:07 PM, Michael Walker <va3mw at portcredit.net> wrote:
> 
> You have to be at the following revision:
> 
> 
>   Rev. A6-2, 15 December, 2017 Copyright © 2017, Elecraft, Inc. All Rights Reserved   
> 
> FM Mode FM Mode
> 
> This added mode is intended primarily for use on the 10 meter band, and repeater as well as simplex
> operations are supported. External transverters may also be used (see KX2 Owner's Manual for set up).
> 
> - To enable or disable FM mode's availability, use MENU:FM MODE. VFO A controls FM on/off. If FM mode is
> enabled, it is available on all bands.
> 
> FM mode must be selected in order to use the controls shown below.
> - To adjust squelch, tap FIL and rotate the AF GAIN knob.
> - To adjust transmit offset frequency (repeater shift or split), use MENU:RPT OFS and VFO A. Offset values can
> be set at 20 KHz increments.
> - To select transmit frequency offset direction, hold SPLIT. The transmit offset direction (+/-/SIMPLEX) will be
> shown on the VFO B display, alongside the transmit offset value. Successive holds of SPLIT will rotate
> through the three offset directions.
> - Transmit offset and direction are remembered on a per-band basis. Saving an FM mode memory stores
> both.
> - FM deviation may be changed with MENU:FM DEV. Use VFO A to set it. You might have to unlock this
> setting in order to change it. Hold the FREQ button down for 3 seconds to clear lock status.
> - PL (CTCSS) tone deviation may be adjusted from within MENU:FM DEV. While in this menu, tap '1' to select
> PL deviation. It can then be changed by rotating VFO A.
> - PL tone frequency may be adjusted using MENU:FM TONE. Tapping '1' turns PL tone on or off. If PL tone is
> turned on, rotating VFO A changes its frequency.
> - 1750 Hz tone burst is not supported at this time.
> 
> Mike va3mw
> 
>> On Sat, Jul 6, 2019 at 8:23 PM Paul Gacek via Elecraft <elecraft at mailman.qth.net> wrote:
>> I’m trying to get an XV144 working for possible SOTA usage.
>> 
>> As I might be operating FM and/or SSB I’ve been searching for squelch control on the KX2 but without luck. Does it support squelch?  
>> 
>> Paul
>> W6PNG/M0SNA 
>> www.nomadic.blog
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to va3mw at portcredit.net