[Elecraft] CW problem

[Don Wilhelm]

John,

The recommended troubleshooting steps in cases like this is to remove 
everything from the K3 except the power cable and the coax to a dummy load.

With that done, does the problem still appear - if so contact 
support at elecraft.com.

If it does not appear, then plug things back in one at a time to see 
which external device is causing the problem.

73,
Don W3FPR

On 7/4/2019 9:34 PM, John and Rita Freitag via Elecraft wrote:
> I am trying to run down a CW transmit problem on my K3s. Anytime I change the mode from LSB or USB on any band to CW it starts to send a “dit” without stopping and I have to halt it by restoring the configuration. This does fix it until I try to switch to CW again; and then, the same story.
>