[Elecraft] The ERR 12V Message Question

[Drew AF2Z]

It's been a while since I did mine but I think disassembly/reassembly 
was a significant part of the effort. I did the front panel connector at 
the same time as the power connector. The actual removal of the 
connectors and soldering new ones went pretty quickly. I'm not sure I'd 
want to go through the disassembly for a "quick fix" only to have to do 
it again in another month.

You might want to refer to online blogs about the process, or Youtube 
videos (if any). Sorry, I don't have the links, but one hint: after you 
snip the connectors off the board use an alligator clip to grasp the pin 
stubs for desoldering; it's easier than trying to manage it with a pair 
of dikes.

73,
Drew
AF2Z



On 07/02/19 21:07, Joseph M. Durnal wrote:
> I'm not sure if I am experiencing the KPA3 power connector issue or
> not.  I've gotten the ERR 12V message twice today.  Powering the K3
> off and on again will clear the message, but it came back, but cleared
> again after a power cycle.
> 
> And, as I type this while transmitting some FT8 in the background, it
> gave me the error message again.  The full Elecraft K3  KPA3 Power
> Connector Replacement  procedure looks like something I won't have
> time to do until next month, is there a quick bandaid I an try until
> then?  Also, is it safe to use the K3 at 10 watts until I get it
> fixed?
> 
> Thanks & 73 de Joseph M. Durnal - NE3R
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to pubx1 at af2z.net
>