[Elecraft] No TX output in data mode

[Bill Weaver]

>  
>  While using my K3 in data A mode with wsjt-x software on 6M, TX stopped, and other data modes also have no TX output. RX remains OK, and CW and SSB TX  &  RX still work OK. Need suggestions on diagnosis or reset process. Direct replies off list are OK. Thanks, Skip W5GAI 

 
> I occasionally have rf get into the laptop and blow it out of the water and everything including the above symptom results. A reboot of the laptop and K3S restart after moving some wires around usually fix it. In my case, better bonding and judicious use of ferrite would cure the problem. I'm still in a "temporary" mode with the station build :-). I'll get there!
 
>
 
> 73
 
> Bill WE5P