[Elecraft] K3s & P3 used with Data

[Nr4c]

Which DATA sub-mode were you using. There are two USB and two LSB sub-modes. 

Sent from my iPhone
...nr4c. bill


> On Jan 31, 2019, at 6:15 PM, Bob <WB4SON at gmail.com> wrote:
> 
> I've been using my K3 & K3s for years using the DATA mode.  It has worked
> as if it were in the USB mode, and shows on the P3 scope to the right of
> the dial frequency just like a USB signal would.
> 
> Today I tried 60 meters for the first time.  I could pick up signals and
> decode them just fine in USB mode, and the P3 showed the signals to the
> right of the dial frequency as expected.  However, when I shifted the radio
> into DATA mode, the P3 seemed to shift as if it was showing a double
> sideband signal (half below the suppressed carrier and half above).  At
> this point, when in DATA mode, nothing would decode until I selected REV
> DATA.  The result of that was that calculated frequencies were wrong
> (appearing that signals were significantly outside the US channel limit.
> 
> Am I missing some setting, or is there something unique about how the DATA
> mode works on 60 meters?
> 
> 73, Bob, WB4SON
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to nr4c at widomaker.com