[Elecraft] Trying to use KPA-1500 on 160

BRUCE WW8II wa8hgx at gmail.com
Thu Jan 24 22:59:46 EST 2019


Pete
I run my KPA1500 on 160 mtrs , with about 20 to 30 watts of drive from my
K3s which gives me 1100 to 1450 watts  out.. You need to be sure to use the
auto tuner in the KPA1500 and be sure the SWR is low enough to operate . If
the SWR is to high, or you over drive the amp, the KPA 1500 amp will go to
fault.
Try starting with a lower drive of 12 to 15 watts for the first pass with
the auto tuner.  Oh and be sure the RF CONNECTORS ARE ALL GOOD AND TIGHT..
A POOR CONNECTION OR A BAD CONNECTOR WILL CAUSE A FAULT WHEN HIGH WATTAGE
IS APPLIED.

Bruce WW8II

On Thu, Jan 24, 2019 at 10:30 PM <john at kk9a.com> wrote:

> Turn down the K3 power with the amp set on Operate.
>
> John KK9A
>
>
> N4ZR n4zr at comcast.net
>
> New owner trying to get ready for the CQWW 160 contest.  Rig is a K3
> with the Aux cable connected.  When the amp is in Standby mode, using a
> dummy load, I'm readily able to deliver 30 watts CW (or 50 or 100) on
> 160 with the tuner bypassed or in. However, as soon as I switch the amp
> to Operate, and send my first dash, I get a hard fault with the LCD
> message input power 67 watts.
>
> I'm guessing it might be a K3 adjustment, but I don't know where to
> look. Any advice much appreciated!
>
> 73, Pete N4ZR
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to wa8hgx at gmail.com
>


More information about the Elecraft mailing list