[Elecraft] Elecraft K2 external amplifier

[Don Wilhelm]

Wolfgang,

Connect K60XV J2 pin 2 to a jack and you will have an Amp Keying output.
There is just barely room to mount an RCA jack on the lower rear panel. 
Look for a clear spot near the Key jack and drill a hole as close to the 
top of the panel as possible while still allowing the jack to not 
project above the top of the panel.

73,
Don W3FPR

On 1/20/2019 8:15 AM, Wolfgang Peringer wrote:
> Hello:
> 
> I have built and installed the K60XV 60m and transverter adapter in my 
> K2. I was using the 8-pin female connector (RF-J13) for my amplifier 
> keying circuit (N0SS design). As this connector is now used for the 
> KX60XV I am looking for a way to key an external amplifier.
>