[Elecraft] KPA500 & Drake TR7
Walter Underwood
wunder at wunderwood.org
Mon Jan 14 23:22:11 EST 2019
I know nothing about the TR7, but I searched the web for "drake tr7 output power adjustment” and found this useful-looking page, with photos.
http://www.wb4hfn.com/DRAKE/DrakeArticles/TR7_ALC_Control/TR7%20ACL%20Control.htm <http://www.wb4hfn.com/DRAKE/DrakeArticles/TR7_ALC_Control/TR7%20ACL%20Control.htm>
wunder
K6WRU
Walter Underwood
CM87wj
http://observer.wunderwood.org/ (my blog)
> On Jan 14, 2019, at 7:56 PM, Gary Smith <Gary at ka1j.com> wrote:
>
> I hesitate to answer to this, it's been so
> long since I had a TR7 (My 2nd rig) and my
> memory of it is not clear.
>
> Given this disclaimer, I believe you'll
> find an adjustable piece, two wafers with
> a rectangular key hole in the center part
> to turn it. Cap or resistance, I don't
> recall what it was, but it controlled the
> output and you could lower it way down or
> get more than the rated output with it (at
> the expense of the transistors if you
> pushed it too long).
>
> I wish I could remember exactly where it
> was, but I believe it was on the heatsink
> or close to it at the back side of the
> rig. Might have been blue, I'm not sure,
> maybe it was accessible from the outside
> of the radio, from the bottom rear? I
> think I'd remember it if I saw the TR7
> again, the adjustment was in plain sight.
>
> I suspect if you backed it down you'll be
> fine with the output from the KPA-500.
>
> For some time the TR7 was used for EME,
> the person who bought mine was modding it
> for that and perhaps in an EME group
> someone might have good knowledge of the
> TR7 and where this was exactly located.
>
> 73,
>
> Gary
> KA1J
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to wunder at wunderwood.org
More information about the Elecraft
mailing list