[Elecraft] KX3 - Mode switch skips AM

[Keith Onishi]

Correction as below;

Tapping MODE switch on my KX3 with MCU 02.90, most latest firmware, switches mode from SSB -> CW -> FM -> FM, then back to SSB. It does skips AM.

73 de JH3SIF, Keith

> 2019/01/14 7:37、Keith Onishi <jh3sif at sumaq.jp>のメール:
> 
> Hello,
> 
> Tapping MODE switch on my KX3 with MCU 02.90, most latest firmware, switches mode from SSB -> CW -> FM, then back to SSB. It does skips AM.
> I have not switched to AM for long time. I think I was able to select AM by tapping MODE before.
> I went through KX3 Owner’s Manual to look for any configuration to skip any specific mode, but found none.
> Sending “MD5;” from KX3 utility software switches KX3 to AM mode. So MPU is OK on selecting a mode except switching the mode by MODE switch.
> I restored my KX3 configuration backed up almost 6 months ago, but the symptom is same. Then I reloaded the latest firmware to my KX3, but the same result.
> 
> Have anyone experienced the similar problem?
> Your though on any possible cause are welcome.
> 
> 73 de JH3SIF, Keith
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to jh3sif at sumaq.jp