[Elecraft] Battery Low K3

[RIchard Williams]

Don,
Yep, my bad. I re-read it, and you are right.  Thanks for the correction. 
Dick, K8ZTT
Sent from Yahoo Mail on Android 
 
  On Sun, Jan 13, 2019 at 12:24, Don Wilhelm<donwilh at embarqmail.com> wrote:   Dick and Chuck,

Please read the description for the BAT MIN on page 54 of the Owner's 
Manual again.
It explicitly states that BAT MIN refers to the main 12v power supply to 
the K3 and NOT to the 3 volt lithium battery.

Check the power supply voltage as read in the ALT VFO B DISPLAY. That 
gives you the voltage seen inside the K3 and if you have voltage drops 
at the connectors for the power cable, it will be shown there.
The usual setting for BAT MIN is 11 volts.

You will NOT be "good to go" even if you replace the lithium 3 volt battery.

73,
Don W3FPR

On 1/13/2019 1:56 PM, RIchard Williams wrote:
> Chuck
>
> An not sure where the people answering your question are obtaining 
> their dis-information from.   In any case, the K3 does indeed have a 3 
> V lithium on the main board.  It is used to power the clock, and it 
> can last from 2 to 10 years.
>
> It is a CR 2032 cell and is located  on the left front side on the RF 
> board.
>
> This information is on page 59 of the K3 assembly manual. 
> Additionally,  it is also on page 54  BAT MIN in the Owner's Manual.
>
> Replace the battery and you will be good to go.
>
>