[Elecraft] [K2] K2 base low xmit power on all bands @ > 10 watts

[K5MMH]

Hello All,

Let me first state that I do not know how long this condition has existed. I
recently added an LP-100 watt meter to my shack and have noticed low
transmit power on all bands (10 thru 160) when power is set to 10 watts or
greater. I have an KPA100, and with it installed, I see no more than 60 to
70 watts max. My K2 is S/N 3010, and I built it new along with all of the
add-ons. To provide the values listed below I removed the KPA100, and
connected the LP-100 (recently re-calibrated by Larry Phipps) directly to
the K2 base BNC antenna connector, with a DL1 dummy load on the load side of
the LP-100 coupler. For input power, I am using a 13.5 VDC  50A power
supply, supplying power to the K2 via barrel jack J3. With power set to 2
watts, I am reading 2+ watts on the LP-100 on all bands. With power set to 5
watts,  I am reading 5+ watts on all bands. Increasing power to 10 watts
results in the following values (and the internal K2 watt meter coincides
with these values) :
10m = 9.60w @ 2.56A current draw (seen on the K2 internal watt meter
display)
12m = 8.80w @ 2.04A
15m = 9.10w @ 1.74A
17m = 9.40w @ 1.80A
20m = 9.40w @ 1.92A
30m = 9.20w @ 3.14A
40m = 10.10w @ 2.76A (the exception, as 40m is above 10w)
80m = 7.20w @ 2.70A
160m = 7.00w @ 3.12A

When power is further increased to 15 watts, these are the readings:
10m = 12.10w @ 3.00A
12m = 10.60w @ 2.24A
15m = 10.10w @ 2.30A
17m = 11.90w @ 2.34A
20m = 11.50w @ 2.50A
30m = 10.00w @ 4.00A
40m = 9.20w @ 4.10A
80m = 7.40w @ 3.80A
160m = 7.30 @ 4.00A

I have gone thru the 40m transmitter alignment and the transmitter alignment
steps outlines on pages 72 and 74 of the manual. I also ordered and just
replaced (two days ago) the PA transistors thinking this was my problem.
But, the issue persists.

Any assistance will be much appreciated.

73

Mike Harang
K5MMH
Franklinton, LA.







--
Sent from: http://elecraft.365791.n2.nabble.com/