[Elecraft] Slip on adapters on PL259s

[Gmail - George]

Bill,
We used the "slip-ons" to have quick reconfiguration of monitors on a live 
remote (TV) truck when we were still using UHF connectors for video.
We had no failures that I remember - remote live trucks live in a very 
hostile environment!

We used the UHF slip-ons until the conversion to BNCs beginning in the early 
70s

73
George   AI4VZ

-----Original Message----- 
From: bill

Here comes the flames:  I use slip on adapters on my PL259s that connect
my rigs/tuners/etc. to the outside world on my bulkhead. I have been
using this method for over 30 years and NEVER had a connector associated
failure. It allows for quick connect/disconnect when shutting down for
thunderstorm related issues. I use RG8X for all indoor coax duties and
run the KPA500 - so no power levels requiring heavier cable. I do snug
PL259s on equipment slightly with pliers.

Fact is, the only coax failure I have had of recent note, was the poor
quality patch cable between the P3 and K3. It was long ago replaced with
a Mil Spec cable from my junk box.

I do use a number of Daiwa 2-position coax switches for various
purposes. Any comments on coax switches?

Bill W2BLC K-Line