[Elecraft] Tx distortion

[mustang65]

Thanks for answers.
The symetrix output impedance is 200 ohm and it is recommended to not load
it
lower then 600 ohms.
I lifted the plus side of c20 and  connected a 10k resistor to ground.
I connected the signal from the symetrix output to the plus side of c20.
This way the signal comes direct to ne602 and u3 is not involved.

The distortion is still the same and no difference what signallevel
I put out from the symetrix. from a very low level until a 3 bars of 
alc reading. I am still listening to the Lf signal from the symetrix just to
be shure
it is no clipping from the unit.

I know this is not the way to drive the k2 just trying to find a way to see
if U3 is the problem.

The microphone I drive the symetrix is a shure sm58 and I also
use a icom hm12 that i put direct in to the K2.
The first 6 years I  used the Icom microphone then  the last 8
years I used the symetrix and Shure sm58 that improved the audio.

73 Mike sm3xgm





--
Sent from: http://elecraft.365791.n2.nabble.com/