[Elecraft] K3 - WSJT-X help

[stephen shearer]

YES, on my KX3.. I have seen (when I change modes, often) that I have 
zero ALC (not 4/5 bars).  IF I turn the mike gain up, still zero.  AT 
THIS POINT, I turn the mike gain to zero and start turning it up.  The 
mike gain was too high and starting over works...  FT8 is working 
again.  I also run wsjt-x with 20db att so that I have "range" with the 
mike gain.  OR what ever it might be with the K3...

73, steve WB3LGC

On 11/13/19 7:39 AM, Don Wilhelm wrote:
> Tony,
>
> Soundcard problem or K3 problem.  This is most commonly a problem with 
> audio into the K3.
>
> How many bars illuminate on the ALC meter?  It should be 4 with the 
> 5th bar flashing.  If not, look at the audio levels.
>
> See the article on my website www.w3fpr.com
>
> 73,
> Don W3FPR
>
> On 11/13/2019 7:04 AM, N2TK via Elecraft wrote:
>> Scratching my head. I was making Q's on FT8 with my K3 and WSJT-X, 
>> v2.0.1
>> when I no longer would get power out.
>>
>> WSJT is keying the K3 (Red transmit light is on) but no power out. 
>> The K3
>> keys fine with power out in CW or other modes is fine. WSJT is 
>> talking to
>> the K3. WSJT shows the correct frequency, it is decoding and when I 
>> go into
>> Settings > Radio and hit Test CAT it goes green. When I hit TUNE on 
>> WSJT it
>> turns to red and the red TX light on the K3 comes on. But no power out.
>>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to sm.shearer.01 at gmail.com .
>