[Elecraft] K3 CW Problem

[Bob McGraw]

Victor's point is a good one.  Thus the question are you working full 
QSK or semi-QSK?   If the  TX Delay is long,  default is about 8 ms as I 
recall,  it will put in the required space for the correct timing to key 
an external amplifier.  This can occur between every CW element in QSK 
mode.    Also there is a Menu value for higher speed CW as opposed to 
what us old slow folks use.

73

Bob, K4TAX

On 12/3/2019 3:33 PM, Victor Rosenthal 4X6GP wrote:
> Do you have CONFIG:TX DELAY set higher than 8 or 10?
>
> 73,
> Victor, 4X6GP
> Rehovot, Israel
> Formerly K2VCO
> CWops no. 5
> http://www.qsl.net/k2vco/
>
> On 03/12/2019 18:38, Keith Lamonica wrote:
>> Am I just missing a setting.  With my K3 CW is fine up to about 
>> 23wpm. Any higher speed results in just spacing change In
>>
>> e.g.
>>
>> I have n1mm cw working fine ….… keyboard on software sends qrq fine … 
>> n1mm sends qrq fine … paddle is stuck at about 20wpm … if I jack up 
>> the speed it increases the character speed bust adds a space so speed 
>> does not do up and it sounds like crap… anything I can do?
>> John k9dx
>>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rmcgraw at blomand.net