[Elecraft] K1 Transmit Offset Adjustment

[Tom Johnson]

I just redid my Transmitter Alignment on my K1, using a wattmeter, which I
didn't have when I originally built it.  I have removed the Antenna Tuner -
now on to redoing my TX Offset - to do that do I leave the Antenna Tuner off
and proceed, or do I reinstall the Antenna Tuner and then proceed with the
TX Offset Alignment?  (As described on page 47 of the manual - the part
where you install a jumper between the OFS pads, turn the AGC OFF, set power
to 1.o watts and Adjust C13.)

 

Any help is much appreciated - I've determined I'm not transmitting on the
same frequency on which I'm receiving and am thus attempting to get the TX
Offset properly set.

 

Tom 

KQ7TJ

 

"I am an old man and have known a great many troubles, but most of them
never happened."

        - Mark Twain