[Elecraft] Foot Extensions fro KAT500/KPA500

[wa2lbi at gmail.com]

I put my KAT500 on the bottom because it made cable management easier.  There are no coax cables hanging over the back of the KPA500 so no strain on the cables/jacks.  A secondary benefit is that the KPA500 vents are unobstructed so no spacing is required.  Ken WA2LBI LG G6 ------ Original message------From: Kevin, N4TTDate: Thu, Aug 15, 2019 16:22To: Elecraft Reflector Reflector;Cc: Subject:Re: [Elecraft] Foot Extensions fro KAT500/KPA500Thanks Ed and Bill. That probably should have been obvious but I have this
issue with overthinking.

Kev


On Thu, Aug 15, 2019 at 3:52 PM Nr4c  wrote:

> Put it on the bottom, it doesn’t generate much if any heat.
>
> Sent from my iPhone
> ...nr4c. bill
>
>
> > On Aug 15, 2019, at 3:46 PM, Kevin, N4TT  wrote:
> >
> > My KAT500 sits on top of the KPA500. The manual says it's OK but I would
> > like to add clearance to improve air flow. Does anyone have an elegant
> > solution to raise the KAT500 above the KPA500?
> >
> > 73,
> > Kev N4TT
> > ______________________________________________________________
> > Elecraft mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/elecraft
> > Help: http://mailman.qth.net/mmfaq.htm
> > Post: mailto:Elecraft at mailman.qth.net
> >
> > This list hosted by: http://www.qsl.net
> > Please help support this email list: http://www.qsl.net/donate.html
> > Message delivered to nr4c at widomaker.com
>
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to wa2lbi at gmail.com