[Elecraft] K3S Frequency Calibration Issue

[Greg Troxel]

John Stengrevics <jstengrevics at comcast.net> writes:

> I have followed the calibration procedure in the manual (WWV as I
> don’t have a frequency generator).  On 50 MHz, I am spot on.  However,
> on 2 meters, I am off by 1 KHz.

Without a calibrated signal generator (or generator and calibrated
counter), how are you measuring this?

> Any suggestions as to how I can get 2 meters to agree?

To agree with what, and how do you know it's right?

It would help if you explained more precisely what you did.  I'm
guessing you used 15 MHz WWV, but then what are you doing on 50 and 144
MHz to measure?  Did you measure 28 MHz?  What are you measuring
against?  How is that calibrated, and how do you know it is correct?

(Also, I am unclear on how the 144 Mhz option works, but that's
important to understand.)