[Elecraft] No Pwr out 20M

[Jim Kennedy]

Thanks Grant NQ5T, when I have finished this post I will proceed to go wipe off the egg on my face. I had gone thru all bands to be sure I had the correct antenna port selected but after Grants post I figured I had better check that again and found it to be incorrect. All is good now. What a bonehead move. Sri for using up the bandwidth. After 65 years on the air I should have known better. Anyways, thanks guys.

Jim
W7OUU

----- Original Message -----
From: "Grant Youngman" <ghyoungman at gmail.com>
To: "elecraft" <elecraft at mailman.qth.net>
Cc: "Jim Kennedy" <kennedyjp at cableone.net>
Sent: Sunday, April 28, 2019 6:04:30 PM
Subject: Re: [Elecraft] No Pwr out 20M

Sounds like you might have inadvertently changed the antenna selection — e.g., ANT 2 when your antenna is on ANT 1.

Grant NQ5T
K3 #2091 KX3 #8342

> On Apr 28, 2019, at 8:01 PM, Jim Kennedy <kennedyjp at cableone.net> wrote:
> 
> Hi all, I'm new to the list. Just turned on my K3 and noticed I have no power out on 20 meters. I have performed all the normal trouble shooting stuff. The transmitter is fine on all other bands and has normal 100w output on a Bird 43 and Bird dummy load. It makes no difference if the rig is in bypass or ATU. It flashes HI SWR. I also put it on one of my antennas on another band and the tuner performed as it should. I suspect the ATU has gone wacky but wanted to consult here just on the off chance I may have missed something. Any input would be appreciated before I take a deep dive into the tuner. Thanks in advance for any help. 
> 
> Jim 
> W7OUU