[Elecraft] K2 VCO Alignment - Low voltage

[Don Wilhelm]

Mark,

See my prior email.

73,
Don W3FPR

On 4/21/2019 1:43 PM, Mark Yergin wrote:
> I'm getting 0.02 V at R30, not 6V.  Turns on T5 correct and wound per
> image.  Reflowed the four solder joints and verified continuity between 1
> and 2, 3 and 4. C72 is correct value (label 271) and reflowed.  L30 is the
> correct value (large slot), and reflowed.  D21-26 confirmed as correct
> values.  C71-74 confirmed as correct values.
> 
> Suggestions?
> 
> Mark W8EWH
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>