[Elecraft] P3 Display issues...

[Eric Swartz - WA6HHQ, Elecraft]

Hi Robin,

Make sure you have the P3 and K3 connected via the 9 pin RS232 cable, and that 
both are at the same baud rate mentioned the manual.

Also, in the P3 menu there is an entry for radio type. Select K3 if it is not 
already entered.

73,

Eric
/elecraft.com/

On 4/18/2019 7:32 AM, oz6abm at qsl.net wrote:
> Hi -
>
>   
>
> I just cannot get this to work for me. I am looking at my P3 connected to a K3. It is connected between the IF In on the P3 and IF Out on the K3. When looking at the P3 display, on all frequencies, I do not see the actual frequency of the VFO, I see 0, for example to top line has -25.0 0 +25.0.
>
>   
>
> On top of that, when I use marker A and move it and press the QSY, nothing happens. What am I doing wrong. The User Guide just says how it should work, but not why it is displaying 0 as center frequency?
>
>   
>
> Thanks,
>
> Robin
>
> OZ6ABM/5P5R
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html