[Elecraft] ERR KEY Message

[Arie Kleingeld PA3A]

Hi Bob,

I've been playing with the RSP1A at the IF of my K3 and HDSDR and SDR 
Uno as panadapter software. I also had Omnirig running for this. Never 
bumped into the kind of problem you describe. I can reproduce your 
problem though, by setting up omnirig with wrong RTS/DTR setting. One 
thing to observe is that you connect OmniRig to the K3 with RTS and DTR 
low. This will probably cure your problem.

HDSDR / SDR Uno and the RSP1A  not really gave me the results I want. My 
best and cheap panadapter is still the IF-Softrock plus my pc-onboard 
soundcard. Software: NAP3 and LP-BRIDGE. Wonderful pieces of software 
(THANK YOU GUYS). They do the trick for a beautiful panadapter (in 
collapsed mode) and flawless integration with the K3 and other software. 
The noise floor might not be as low as in the P3 of LP-pan, but it works 
for me as a panadapter.

73

Arie PA3A

Op 17-4-2019 om 03:57 schreef Bob Conder via Elecraft:
> Been trying to configure SDR Uno with RSP2 as a spectrum scope. (Using IF output to RSP) But not much luck.Right now, when I turn on SDR Uno, with the K3 already in CW mode, the SDR keys the rig for a moment, then stops.The "ERR KEY" message shows up on the screen.Can't get the message to clear, and can't send CW, so have to pwr down the rig, to get the error message to clearand to be able to operate the K3 agn.Anyone else with SDR Uno/RSP2 have this problem?Any suggestions appreciated.TIA,Bob K4RLC