[Elecraft] K3 DSP firmware update 'Missing'

[David Aslin G3WGN]

Thanks Grant and several others offline. I'm now up-and-running courtesy of your suggestions. I have no idea why Utility couldn't pull the dsp firmware off the Elecraft ftp site, but could access all the firmware downloaded to a thumb drive.

So now continuing trial pack and inventory check for VK9XG...
73 David G3WGN M6O



Sent from my Samsung Galaxy smartphone.


-------- Original message --------
From: Grant Youngman <ghyoungman at gmail.com>
Date: 22/09/2018 15:07 (GMT+00:00)
To: David Aslin G3WGN <david at aslinvc.com>
Cc: elecraft at mailman.qth.net
Subject: Re: [Elecraft] K3 DSP firmware update 'Missing'

Since you are looking at the FTP site, just download all of the files from there to a local folder.  Then browse to that local folder with Utility instead of having Utility do the download.

Grant NQ5T
K3 #2091 KX3 #8342

On Sep 22, 2018, at 9:39 AM, Dave G3WGN M6O <david at aslinvc.com<mailto:david at aslinvc.com>> wrote:

Update: on further examination when I 'Copy new files from Elecraft' in the
utility, it responds with '2 files copied' then waits for the download.
Clearly it must need to copy more than two files for MCU, FPF and DSP. I can
see all the needed files on the Elecraft ftp site, but the utility is not
copying the DSP 2.88 files that are there.
In case my anti-virus/anti-malware software was interfering with the copy
process, I temporarily switched it off.  No difference, still reported 2
files copied, no DSP.
73, David G3WGN M6O